Please refer to these window drawings whenspeaking to the Sew Fine representative.

InsideThe Casing Installation

Window treatments can be mounted inside a window casingby following these simple steps.  Please keep in mind that a minimumof 1"x1" flat surface is required for the mounting brackets.  To determinethe inside measurements for the window:

• Measure the width...distance across from one inside faceto the other.  Measure at three (3) different places, and use thenarrowest dimension when ordering (A dimension).  It is critical tomeasure the top width on the inside mount where the headrail will be mounted. The factory will automatically deduct 1/2" from the inside measurementfor slat width to allow for out-of-square window casings.
• Measure the height...distance from top (soffit) down to thesill.  If no sill, or an overlap is desired, measure to the lowestpoint you want the blind to reach (B or C dimension).
• Measure the sill height...distance from the sill to the floor. This will ensure that the operating controls are made to the proper length(D dimension)

Outside TheCasing Installation

Window treatments can be mounted outside a window casing,providing there is a minimum of 1"x1" flat surface for the mounting brackets. It is resommended that the blinds overlap the window opening by at least2" on each side (total 4") to ensure privacy and to control sunlight. To determine the outside measurements for the window:

• Measure the width...distance across, taking into accountat least 2" overlap on each side (A dimension).
• Measure the height...distance from the top (where the mountingbrackets will be) to the top of hte sill.  If no sill, or an overlapis desired, measure to the lowest point you want the blind to reach (Bor C dimension).
• Measure the sill height...distnace from teh sill to the floor. This will ensure the operating controld are made to the proper length (Ddeminsion).